The set includes 5 A-Foil sheets (A4 format, chosen colour) + 5 B-paper sheets (A4 format).

Flex-Soft (No cut) is a two-paper system for LED/laser printers with and without white toner. You can print single-colour transfer images without using special printers. Now you can transfer designs in white, metallic and neon colours, without special toner and without plotting. For printing on almost all types of fabric and hard surfaces (cotton, blended fabrics, polyester, nylon, polypropylene, paper, wood, etc.). Incredible design and motif possibilities. Fine details and complex graphics can be transferred without problems.

Print settings: 

Paper Setting: Film, Foil, Transparency
Print Setting: Multi-Purpose Tray, Single Sheet Feeder
Image Mode: Mirror Image

Colour settings for printing: 

Printer B&W: all colours: 100% black
Printer CMYK: all colours: 400% (Cyan 100% + Magenta 100% + Yellow 100% + Black 100% = 400% Black)
Printer with white toner: Neon colours – 100% White, Standard and metallic colours: 300% Black (Cyan 100% + Magenta 100% + Yellow 100% = 300 Black)

Printing:

Print the image mirrored onto the A-Foil material. Trim 1cm around the A-Foil image so that it is smaller than the B paper.

Heat press preparation:

Press the press until the lower surface is hot.

Transfer:

1. To protect the silicone surface, place 1–2 sheets of ordinary paper on it.
2. Place the A-Foil on the heat press surface (printable side up).
3. Place the B-paper on the A-Foil (white layer facing down).
4. Place 1–2 sheets of paper over everything to keep the heat press from getting dirty.

Heat press settings:

Temperature: 130 – 145C
Time: 90 seconds
Pressure: 2-3 bar

For bright designs with CMYK and white, increase the transfer time to 120 seconds.

After heat transfer, peel off the papers slowly and evenly.

Image on clothing:

1. The image must be cut out so that the melt residue is also trimmed off the B paper.
2. Place the fabric or other material on the lower heat press platen. Secure the A-Foil with heat transfer tape.
3. Place baking paper on top and use the parameters depending on the fabric (see the table in the PDF attachment with instructions).
4. Remove the A-Foil when it has cooled down.
5. To give a matt effect and make the cotton item washable, cover the image with matt permanent paper and fix at 180 – 200°C for 30 seconds.